错误代码： 10.22.15 | 惠普5系激光打印机 故障代码 其他系列也可以参考 | 二〇二一年五月二十七日
2021-06-01
错误代码： 10.22.15 | 惠普5系激光打印机 故障代码
其他系列也可以参考 | 二〇二一年五月二十七日
--------------------------------------------------
技术热线：朱师傅整理
--------------------------------------------------
中文译本：
10.22.15安装传输单元描述
传输单元已被卸下或安装不正确。
建议操作
安装转印单元。如果已安装，请卸下转印单元，然后重新安装。
如果打印机找不到ITB接触疏离原位，请检查ITB疏离传感器SR5。
在组件测试中使用ITB联系/异化来验证ITB异化机制是否为
运作正常。如果不是，请更换定影驱动器组件。
注：更换定影驱动器组件涉及卸下主驱动器组件。只执行这个
与HP支持人员联系后采取的步骤。
检查并重新连接T1滚筒异化传感器的连接器（J15），以及连接器上的连接器（J2504和J2502）。
DC控制器PCA上的高压电源T PCA和连接器（J131）。
--------------------------------------------------
英文解释：
10.22.15 Install transfer
unit
Description
The transfer unit has been removed or is installed incorrectly.
Recommended action
Install the transfer unit. If already installed, remove the transfer unit and then reinstall it.
If the printer could not find the ITB contact alienation home position, check the ITB alienation sensor SR5.
Use the ITB Contact/Alienation in the Component Test to verify that the ITB alienation mechanism is
functioning properly. If it is not, replace the fuser drive assembly.
NOTE: Replacing the fuser drive assembly involves removing the main drive assembly. Only perform this
step after contacting HP support.
Check and reconnect the connector (J15) of the T1 roller alienation sensor, connectors (J2504 and J2502) on
the high-voltage power supply T PCA and connector (J131) on the DC controller PCA.
Description
The transfer unit has been removed or is installed incorrectly.
Recommended action
Install the transfer unit. If already installed, remove the transfer unit and then reinstall it.
If the printer could not find the ITB contact alienation home position, check the ITB alienation sensor SR5.
Use the ITB Contact/Alienation in the Component Test to verify that the ITB alienation mechanism is
functioning properly. If it is not, replace the fuser drive assembly.
NOTE: Replacing the fuser drive assembly involves removing the main drive assembly. Only perform this
step after contacting HP support.
Check and reconnect the connector (J15) of the T1 roller alienation sensor, connectors (J2504 and J2502) on
the high-voltage power supply T PCA and connector (J131) on the DC controller PCA.
--------------------------------------------------
实际故障案例
3】故障案例：
--------------------------------------------------
2】故障案例：
--------------------------------------------------
1】故障案例：
扫描开通重新登录查看更多
添加朱师傅微信咨询
