错误代码： 57.00.01 | 惠普5系激光打印机 故障代码 其他系列也可以参考 | 二〇二一年五月二十七日
2021-06-01
错误代码： 57.00.01 | 惠普5系激光打印机 故障代码 其他系列也可以参考 |
二〇二一年五月二十七日
--------------------------------------------------
技术热线：朱师傅整理
--------------------------------------------------
中文译本：
57.00.01送风扇（FM3）故障描述
打印机出现排气扇（FM3）故障
建议操作
1.关闭打印机，然后再打开。
2.重新连接高压电源T PCA上的连接器（J2505）和高压电源TPCA上的连接器（J109）。
直流控制器PCA。
3.更换排气扇。
注意：技术人员可以测量直流电连接器（J109-8和J109-9）之间的电压
打开打印机电源后立即启动控制器PCA。如果电压从0V变为
大约24V，更换输送风扇。如果不存在电压，请检查其他风扇和风扇的电压。
根据需要更换直流控制器。
--------------------------------------------------
英文解释：
57.00.01 Delivery Fan (FM3)
failure
Description
The printer experienced Exhaust Fan (FM3) failure
Recommended action
1. Turn the printer off, then on.
2. Reconnect the connector (J2505) on the high voltage power supply T PCA and connector (J109) on the
DC controller PCA.
3. Replace the exhaust fan.
NOTE: Technicians can measure the voltage between the connectors (J109-8 and J109-9) on the DC
controller PCA immediately after the printer is turned on. If the voltage changes from 0V to
approximately 24V, replace the delivery fan. If Voltage not present check voltages for other fans and
replace the DC Controller as needed.
Description
The printer experienced Exhaust Fan (FM3) failure
Recommended action
1. Turn the printer off, then on.
2. Reconnect the connector (J2505) on the high voltage power supply T PCA and connector (J109) on the
DC controller PCA.
3. Replace the exhaust fan.
NOTE: Technicians can measure the voltage between the connectors (J109-8 and J109-9) on the DC
controller PCA immediately after the printer is turned on. If the voltage changes from 0V to
approximately 24V, replace the delivery fan. If Voltage not present check voltages for other fans and
replace the DC Controller as needed.
--------------------------------------------------
实际故障案例
3】故障案例：
--------------------------------------------------
2】故障案例：
--------------------------------------------------
1】故障案例：
扫描开通重新登录查看更多
添加朱师傅微信咨询
